Malvern 1020 handleiding

Bekijk hier gratis de Malvern 1020 handleiding. Heb je de handleiding gelezen maar geeft deze antwoord op je vraag? Stel dan je vraag op deze pagina aan andere Malvern 1020 bezitters.

USER INSTRUCTIONS
tentwenty & twentytwentysix
CONDENSING BOILERS
INFORMATION CONCERNING YOUR BOILER
You are the owner of a Malvern High Efficiency Condensing Boiler and due to the
way it works it will appear to produce a lot of steam from the terminal; this is harmless
vapour and quite normal. The boiler requires a drain to be permanently connected,
your installer has done this, it must not be disconnected or removed. The Installer
should also have left you your Logbook. The Gas Safety (Installations
and Use) Regulations makes it illegal for gas appliances to be installed or serviced
by persons not CORGI Registered Operatives. All Registered Installers carry a
CORGI ID card and have a registration number and this should be recorded in your
Logbook. You can check your installer is CORGI registered by calling CORGI direct
on:- 01256 372300
IMPORTANT: DO NOT DISTURB APPLIANCE CASE.
ELECTRICAL SUPPLY TO YOUR BOILER
The boiler must be connected to a 230v ~ 50 Hz supply with a 3 Amp fuse rating.
THE APPLIANCE MUST BE EARTHED.
TO IGNITE YOUR BOILER
With the Electricity supply switched on, the
power
lamp will be on. When the
system programmer and thermostats are in a demand position and the front panel
boiler thermostat fully clockwise, the boiler
running
lamp will be lit and the boiler
will start automatically. The
running
lamp will go out when the system thermostats
are satisfied or if the programmer is off.
If the boiler fails to start and the
lockout
lamp is lit reset by turning the boiler
thermostat to off then back on again.
If the boiler does not start after using the reset allow the boiler to cool, then reset
again. If this still does not succeed in getting the boiler to run, or if a fault is suspected
turn the boiler and supply off and call the assistance of a Corgi registered Engineer.

Vraag over de Malvern 1020?

Stel de vraag die je hebt over de Malvern 1020 hier eenvoudig aan andere productbezitters. Zorg voor een duidelijke en uitgebreide omschrijving van het probleem en je vraag. Hoe beter je probleem en vraag is omschreven, hoe makkelijker het is voor andere Malvern 1020 bezitters om je van een goed antwoord te voorzien.