ec hnica l d a ta
59. 5 cm
ig ht 8 5 c m
pth 53, 5 cm
om 1 to 7 kg
refer t o t h e tech n ical dat a
fix ed t o t h e machin e
a ter c onnections
i mu m p r es s u re 1 MPa ( 1 0 ba r)
imu m p res su re 0 .05 MPa ( 0.5 bar )
u m capa ci t y 5 2 li t r es
up to 1000 rota
tions pe r minute
di ng to
og r amm e 2 ; t emper at u r e 6 0 °C;
s i n g a l o ad o f 7 k g .
ap pl ia nce co nfo rm s to the
wing E C Dir ec tiv es:
336/ EE C da te d 03/ 05/89
omagn et ic Compatibi li ty) an d
se q ue nt m od if ic a tio ns
2 0 0 6 /9 5 / EC L ow V olt age)
65 - 100 cm
the drain hose
the drain hose,
bending it, to a
duct or a wall
located at a height
65 and 100 cm
, rest it on
side of a washbasin
bathtub, fastening the
supplied to the tap
see figure ). The free end
the hose should not
We advise against the use of hose extensions; if it is
necessary , the extension must have the
diameter as the original hose and must not
150 cm in length.
plugging the appliance into the electricity
make sure that:
the socket is earthed and complies with all
the socket is able to withstand the maximum power
of the appliance as indicated in the T echnical
table (see opposite);
the power supply voltage falls within the values
in the T echnical data table (see opposite);
the socket is compatible with the plug of the
machine. If this is not the case, replace
socket or the plug.
The washing machine must not be installed
even in covered areas. It is extremely
to leave the appliance exposed to rain,
and other weather conditions.
When the washing machine has been installed, the
socket must be within easy reach.
Do not use extension cords or multiple sockets.
The cable should not be bent or compressed.
The power supply cable must only be replaced by
The company shall not be held responsible
the event that these regulations are not respected.
the appliance has been installed, and before
use it for the first time, run a wash cycle with
and no laundry , using the wash cycle 3 .