This instruction manual should be kept in a safe
for future reference. If the washing machine is
transferred or moved, make sure that the
manual remains with the machine so that
new owner is able to familiarise himself/herself
its operation and features.
Read these instructions carefully: they contain vital
relating to the safe installation and
of the appliance.
Unpacking and levelling
Remove the washing machine from its packaging.
Make sure that the washing machine has not been
during the transportation process. If it has
damaged, contact the retailer and do not
any further with the installation process.
Remove the 4
rubber washer with
, located on the
part of the appliance
see figure ).
Close off the holes using the plastic plugs provided.
Keep all the parts in a safe place: you will need
again if the washing machine needs to be
to another location.
Packaging materials should not be used as toys for
Install the washing machine on a flat sturdy floor ,
resting it up against walls, furniture cabinets
If the floor is not
for any unevenness
tightening or loosening
adjustable front feet
see figure ); the angle of
to the worktop,
not exceed 2°.
the machine correctly will provide it with
, help to avoid vibrations and excessive noise
prevent it from shifting while it is operating. If it is
on carpet or a rug, adjust the feet in such a
as to allow a sufficient ventilation space
the washing machine.
the electricity and water
the water inlet hose
Connect the supply
by screwing it to a
water tab using a ¾
to run freely until it
perfectly clear .
Connect the inlet hose
the washing machine
screwing it onto the
the appliance, which is
on the top right-
side of the rear part
the appliance (see
Make sure that the hose is not folded over or bent.
The water pressure at the tap must fall within the
indicated in the T echnical details table (see
If the inlet hose is not long enough, contact a
shop or an authorised technician.
Never use second-hand hoses.
Use the ones supplied with the machine.