Conair BE151T

Conair BE151T handleiding

(1)
  • IMPORTANT SAFETY
    INSTRUCTIONS
    WHEN USING ELECTRICAL APPLIANCES, BASIC
    SAFETY PRECAUTIONS SHOULD ALWAYS BE
    TAKEN, INCLUDING THE FOLLOWING:
    READ ALL INSTRUCTIONS
    BEFORE USING APPLIANCE
    KEEP AWAY FROM WATER
    DANGER TO REDUCE THE RISK
    OF ELECTRIC SHOCK: ALWAYS UNPLUG THIS
    APPLIANCE FROM THE ELECTRICAL OUTLET
    BEFORE CLEANING.
    WARNING TO REDUCE THE RISK
    OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO
    PERSONS:
    1. Unplug from outlet before putting on or taking
    off parts.
    2. This mirror should not be used by or near children
    or individuals with certain disabilities.
    3. Use this mirror only for its intended use as
    described in these instructions. Do not use
    attachments not recommended by the manufacturer.
    4. Never operate this mirror if it has a damaged cord
    or plug, if it is not working properly, if it has been
    dropped or damaged, or dropped into water. Return
    the mirror to a service center for examination and
    repair.
    5. Keep the cord away from heated surfaces.
    6. Never drop or insert an object into any opening.
    7. Do not use outdoors.
    8. Do not operate where aerosol (spray) products are
    being used or where oxygen is being administered.
    9. To disconnect, turn all controls to the OFF position,
    then remove plug from outlet.
    10. Do not leave appliance unattended when it is
    plugged in.
    11. Be sure mirror is not in a position where it can
    reflect sunlight; reflected sunlight can cause fire.
    12. Do not use on a soft surface such as a bed,
    where openings may be blocked.
    13. Turn switch to OFF position, allow unit to cool
    and unplug cord before replacing light bulbs.
    14. Do not place or store appliance where it can fall
    or be pulled into a tub or sink.
    15. If an appliance falls into water, unplug it
    immediately. Do not reach into the water.
    16. To protect against electrical hazards, do not use
    while bathing or in the shower.
    17. Never use while sleeping.
    18. Do not use a bulb greater than 20 watts.
    Use on any 120 volt 60 hertz AC electric outlet
    (ordinary house current). Do not use it on any other
    electrical outlet.
    FOR HOUSEHOLD USE ONLY
    SAVE THESE
    INSTRUCTIONS
    OPERATING
    INSTRUCTIONS
    To reduce the risk of electric shock, this mirror has a
    polarized plug (one blade is wider than the other). This
    plug will fit in a polarized outlet only one way. If the
    plug does not fit fully in the outlet, reverse the plug.
    If it still does not fit, contact a qualified electrician
    to install the proper outlet. Do not change the plug in
    any way.
    CAUTION: BE SURE DIRECT SUNLIGHT DOES
    NOT STRIKE MIRROR WHEN LEFT UNATTENDED;
    REFLECTED SUNLIGHT CAN CAUSE FIRE.
    1. Your circular, lighted makeup mirror will rotate
    360º so that you can use either the normal view
    or the 7x magnification view located on the
    opposite side.
    2. Plug cord into any standard 120 volt wall outlet.
    To turn on light, simply turn the switch on the line
    cord to ON setting.
    3. After use, always turn switch to the OFF position.
    4. The beauty and design of this mirror complement
    any decor. Therefore, you may wish to leave the
    mirror displayed. However, if you choose to store
    the mirror, see section about storage for detailed
    information.
    TO REPLACE BULB
    CAUTION: TURN OFF POWER AND UNPLUG.
    ALLOW TO COOL AT LEAST 3 MINUTES BEFORE
    REPLACING BULB.
    Contact a Conair
    ®
    Service Center at 1-800-3-CONAIR
    for replacement bulb information (ask for replacement
    bulb RP-BE151T. Bulbs are $1.50 each; includes
    shipping and handling).
    1. Remove the two screws located on each side of the
    mirror. (Fig. 1).
    2. Carefully lift off the removable housing from the half
    that is affixed to the stand.
    3. Unscrew the old bulb and replace with new bulb.
    (Fig. 2)
    4. Carefully replace the removable half after aligning
    the screw holes to the fixed half.
    5. Insert screws into screw holes and tighten.
    Figure 1
    Figure 2
    09PM16534_be151t_ib_MECH.indd 109PM16534_be151t_ib_MECH.indd 1 10/9/09 4:09:03 PM10/9/09 4:09:03 PM
Conair BE151T

Hulp nodig?

Aantal vragen: 0

Heeft u een vraag over de Conair BE151T of heeft u hulp nodig? Stel hier je vraag. Zorg voor een duidelijke en uitgebreide omschrijving van het probleem en je vraag. Hoe beter je probleem en vraag is omschreven, hoe makkelijker het is voor andere Conair BE151T bezitters om je van een goed antwoord te voorzien.

Bekijk hier gratis de handleiding van de Conair BE151T. Deze handleiding valt onder de categorie Spiegels en is door 1 mensen gewaardeerd met een gemiddelde van een 6.6. Deze handleiding is beschikbaar in de volgende talen: Engels. Heeft u een vraag over de Conair BE151T of heeft u hulp nodig? Stel hier je vraag

Conair BE151T specificaties

Algemeen
Merk Conair
Model BE151T
Product Spiegel
EAN 74108219015
Taal Engels
Bestandstype PDF
Technische details
Kleur van het product Chroom

Handleidi.ng

Op zoek naar een handleiding? Handleidi.ng zorgt er voor dat je binnen no-time de handleiding vindt die je zoekt. In onze database zitten meer dan 1 miljoen PDF handleidingen van meer dan 10.000 merken. Elke dag voegen wij de nieuwste handleidingen toe zodat je altijd het product zal vinden wat je zoekt. Het is heel eenvoudig: typ in de zoekbalk de merknaam en het type product en je kan direct de handleiding van je keuze gratis online bekijken.

Handleidi.ng

© Copyright 2020 Handleidi.ng. Alle rechten voorbehouden.

We gebruiken cookies om er zeker van te zijn dat je onze website zo goed mogelijk beleeft. Als je deze website blijft gebruiken gaan we ervan uit dat je dat goed vindt.

Meer info