Chief SLM256 handleiding

Chief SLM256
7.9 · 1
PDF handleiding
 · 1 pagina
handleidingChief SLM256


Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-002046 Rev00
©2009 Milestone AV Technologies,
a Duchossois Group Company

SSB-256, SSM-256, SLB-256 and SLM-256 Interface Brackets

SSB-256, SSM-256, SLB-256 and SLM-256 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation: All appropriate screws come pre-installed in the circled locations.
DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style interface bracket installation.

Installation Instructions

DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place three spacers on bottom of projector, aligning them with three threaded inserts on bottom of projector.
4. Place interface bracket onto spacers on bottom of projector, aligning the mounting holes in bracket with threaded inserts in bottom of
projector, and ensuring that triangle in bracket points towards front of projector.
5. Position two M4 x 16mm pan head mounting screws with two M4 flat washers into the outside threaded inserts, and the M4 x 16mm flat
head mounting screw into the threaded insert at front of bracket. Tighten all fasteners at this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the
All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (1) Screw, Phillips Flat Head, Machine, M4 x 16mm
(4) 10-24 Thumb Nuts ** (2) Screw, Phillips Pan Head, Machine, M4 x 16mm
(1) All-Points Security Kit (2) Washer, M4
(1) 5/32" Security Hex Key (3) Spacer, .50 x .218 x .25
Towards front
of projector
Towards front
of projector
SLB-256 SLM-256


Bekijk hier gratis de handleiding van de Chief SLM256. Deze handleiding valt onder de categorie Projector accessoires en is door 1 mensen gewaardeerd met een gemiddelde van een 7.9. Deze handleiding is beschikbaar in de volgende talen: Engels. Heeft u een vraag over de Chief SLM256 of heeft u hulp nodig? Stel hier je vraag

Hulp nodig?

Heeft u een vraag over de Chief SLM256 en staat het antwoord niet in de handleiding? Stel hier je vraag. Zorg voor een duidelijke en uitgebreide omschrijving van het probleem en je vraag. Hoe beter je probleem en vraag is omschreven, hoe makkelijker het is voor andere Chief SLM256 bezitters om je van een goed antwoord te voorzien.

Aantal vragen: 0

Chief SLM256 specificaties

Hieronder vindt u de productspecificaties en de handleiding specificaties van de Chief SLM256.

Merk Chief
Model SLM256
Product Projector accessoire
EAN 0841872144269
Taal Engels
Bestandstype Handleiding (PDF)
Gewicht en omvang
Gewicht verpakking 2000 g
Logistieke gegevens
Aantal per verpakking 1 stuk(s)
Merkcompatibiliteit -
Kleur van het product Zwart
Type product -
toon meer

Veelgestelde vragen

Het antwoord op uw vraag niet in de handleiding kunnen vinden? Wellicht staat het antwoord op uw vraag hieronder in de meest gestelde vragen over de Chief SLM256.

Staat je vraag er niet tussen? Stel hier je vraag

Geen resultaten